" After receiving the product, please charge it fully before using it to get the best results. This machine can weld 0.1-0.15mm nickel steel sheet and 0.1 pure nickel sheet. It is not to weld pure copper materials with strong conductivity.one full charge can complete the welding of hundreds of solder joints.\n This is equipped with 3.7V, 5.5AH lithium battery. After the single-chip microcomputer detects that the soldering pen touches the nickel sheet, it controls the \"MOS\" to turn on. Since the resistance of the soldering pen contacting the nickel sheet is much greater than that of other parts of the loop, most of the energy is concentrated here. The way of heating, the nickel sheet is Consumed, and the nickel sheet is welded to the battery.\n When the product is not used for a long for time, the battery power should not be kept too low or too high. If the power consumption is too low, the machine will not work and the charging light will not turn on. When this happens, please charge it, and it will recover after tens of minutes.\n Current, voltage, and materials can affect the spot welding effect. Not all materials can get a good spot welding effect. What can now be adjusted is the spot welding for time and contact strength. It is recommended to practice hands with iron cans first, and then solder the battery after getting familiar with the welding machine.\nLow Standby Power Consumption: : Long press the spot welding for 3 seconds, the buzzer sounds to complete the on/off operation, low power consumption soft and hard design, the measured current of a few A when off, low power consumption in standby mode.\nThe product is equipped with a charging cable and no charger for head. Please use a charging for head with a fixed 5V output for charging. Do not use a fast charging for head, otherwise the battery may be damaged.\nSize: 142*82*40mm":