ESP32-C3 is a low-cost microcontroller from Espressif that supports 2.4 GHz Wi-Fi and Bluetooth? Low Energy ( Bluetooth 5 (LE)).Use RISC V as the core.There's a minimum number of pins on this chip, it's specifically designed to be low cost and for simpler projects than ESP32- or ESP32 classics with their large number of GPIO. Think of it more as an intended replacement to the ESP8266 than to the ESP32! It has built-inUSB-to-Serial, but not native USB - it cannot act as a keyboard or disk drive. The chip used here has 4MB of Flash memory, 400 KB of . The ESP32-C3 integrates a rich set of peripherals, ranging from UART, I2C, I2S, remote control peripheral, LED PWM controller, general DMA controller, TWAI controller, USB Serial/JTAG controller, temperature sensor, and ADC. It also includes SPI, Dual SPI, and Quad SPI interfaces. There is no or native capacitive touch. With its state-of-the-art power and RF performance, this SoC is an ideal choice for a wide variety of application scenarios relating to the Internet of Things (IoT), wearable electronics, and smart homes. Features based ESP32-C3FH4 WIFI & Bluetooth LE RISC-V Single-Core CPU Type-C USB 4MB Flash 11x IO 1x1.0-4P connector(GND,3V3,SDA(GPIO5),SCL(GPIO6)) 1x RGB(GPIO2) 1x LED(3.3V Power Supply) 1x Reset button(CHIP_EN,great for restarting your program or entering the ROM bootloader) 1x Boot button(GPIO9,entering the ROM bootloader or for user input) Compatible with MicroPython, for and ESP-IDF 3.3V Regulator with 500mA output Ceramic Antenna size: 23.5 x 18 mm Material: PCB colour: Package Contents: 2 x Development board Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.