Output of 8 IO ports Debug Pin Combined firmware to achieve analyzer function The DC debugger is a small programmer and debugger for the low power RF system in It can be used with the integrated IAR workbench for 8051(version 7.51A or later)to debug And SmartRF Flash programmer for flash programming The DC debugger can also be used to control SmartRF Studio devices Table content: DC debugger 10-pin flat cable with 2.54mm connector The DC debugger can be used to and debug the following system-based in 8051 of : CC1110...CC1111 CC2430...CC2431 CC2510...CC2511 CC2530...CC2531...CC2533 CC2543...CC2544...CC2545 It is possible to control the same devices from SmartRF Studio. In addition, CC-Debugger can control the following SmartRF Studio transceivers: CC1120...CC1121...CC1125...CC1175 CC1100...CC1101...CC110L...CC113L...CC115L CC2500...CC2520 It can also be used to PurePath wireless devices: CC8520...CC8521 CC8530...CC8531 The DC debugger works with IAR EW8051 version 7.51A or later Product Introduction: Operating frequency:2.405-2.485 GHz Wireless transmission speed:250 Kbaud Power consumption:Less than 20 mA (reception); Less than 25 mA (transmission) Colour:Black Material:plastic Package Contents: 1 x CC2531 Sniffer Board with antenna 1 x Programmer Downloader Cable 1 X CC Debugger Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.