Condition: Item Type: Orthodontic Dental Adhesive Optional Type: Large Set, Small Set Material: Plastic Service Life: 18 Months Storage Condition: Keep below 25°C (do not freeze) Suitable for: All kinds of dental orthodontic attachment adhesion Main Technical Performance Index: - Curing time not more than 300 seconds - Adhesive shear strength >17.2 MPa Usage: 1. Tooth preparation: Clean the enamel surface of the teeth, remove dirt, rinse thoroughly with water, isolate the teeth, and dry the surface with oil-free and moisture-free air. 2. Acid etching: Apply acid etching agent to the tooth surface, rinse thoroughly after 50–60 seconds, then dry. The etched surface should appear chalky; if not, extend the etching time. 3. Primer application: Apply a thin layer of primer to the etched tooth surface using a bristle brush. Use another brush to apply a thin layer to the bonding surface of the brackets (wet bonding is sufficient). 4. Bonding: Apply a small amount of adhesive paste to the bracket base using a mixing rod to form a thin, even layer. Immediately place the bracket onto the tooth surface. Adjust position within 20 seconds and apply light pressure for 5–10 seconds to prevent movement. Remove excess material after 40–60 seconds. Allow to cure for 5 minutes before performing orthodontic procedures. Features: - Designed for bonding various dental orthodontic attachments - Easy to use with minimal waste - Provides high clinical bond strength - Efficient and convenient application - Advanced enamel adhesive resin formulation - Complete accessory set options available - Two set sizes to choose from based on individual needs