This electric longboard skateboard control system features an EMP control module with a remote module, providing stable performance similar to an ESC but with improved durability. Made from high-quality chips and electronic components, the dual-drive design delivers excellent and consistent performance. The robust main board construction significantly extends service life. Includes a remote receiver module for remote control functionality. The well-organized circuit board is designed for easy installation, though professional skills are recommended. Comes with a portable controller featuring an ergonomic design for comfortable handling. Offers 4 speed modes: high-speed sport mode, high-speed economy mode, mid-speed mode, and low-speed mode. Equipped with an LED indicator that displays signal status, speed mode, and battery level. Features: - Suitable for use with scooters, wheelbarrows, torsion carts, balance cars, and similar applications - Upgraded dual-motor drive system with double-layer PCB design for enhanced performance - Wireless 2.4G remote control with a maximum operating distance of up to 20 meters - Compatible with single or manual motor drive for hub motors - Supports belt motors including 5055, 5065, 6354, 6374, and 6384 models - Built-in protections: overvoltage, undervoltage, overcurrent, overheating, (blocked rotor), CW/CCW rotation, and speed control Specifications: - Rated Voltage: 36V - Current: 12A - Rotation Speed: 4200 RPM - Drive Mode: Dual Motor Drive - Maximum Speed: 35 km/h - Power: 430W (36V) - Weight: approximately 250g (8.82 oz) - Maximum Load Capacity: 120kg (264.55 lbs) - Remote Control Range: 20m (65.62 ft) maximum - Sending Method: Hall - Power Connector: XT60 plug - Hall Interface: 5-pin 2.0 connector - Motor Plug: 4mm banana plug - Dimensions: approx. 18.5 x 10 x 5cm (7.28 x 3.94 x 1.97 inches) Installation Instructions: 1. Connect the main control unit to the power supply. 2. Turn on the power and wait two seconds, then press and hold the button for about 6 seconds until the switch indicator begins to flash. 3. Turn on the remote control and use a small screwdriver to press the button inside the small hole in the lower-left corner of the remote. 4. Turn off the remote for two seconds, then turn it back on. Wait for the remote signal light and switch signal light to flash simultaneously, indicating successful pairing. Package Includes: - 1 x ESC Substitute Control Module - 1 x USB to Micro USB Cable - 1 x LED Battery Indicator - 1 x 2.4G Remote Control Transmitter - 1 x Switch