FrSky 5 ch telemetry 2,4Ghz, ACCST, VD5M
FrSky 5 channel receiver with telemetry. Suitable for indoor and small airplanes/helicopters. Range > 300 meters. Weight only 2.0g 1.Introduction 1.1 Compatibility: Channels Connected by Binding Cable Mode of VD5M FrSky Compatible Modules CH1 & CH5 V8 Mode (Non-telemetry) V8FT, V8JT, V8HT DFT, DJT, DHT, DHT-U in V8 Mode (Switch 1 OFF, Switch 2 ON) CH2 & CH5 D Mode (Telemetry) DFT, DJT, DHT, DHT-U in D Mode (Switch 1 OFF, Switch 2 OFF) 1.2 Specifications : Dimension: 21*16*5.8mm Weight: 2.0g / 1.6g (naked) Number of Channels: 5 Operating Voltage Range: 3.0V-7.2V Operating Current: 20mA Operating Range: >300M Connector Specification: 1.25mm pitch 1.3 Features 1) Super small and light, designed for park flyers and indoor aircrafts; 2) Compatible with all FrSky modules (V8 mode & D mode), receive only (VD5M can talk with module of either mode, but it does not send any telemetry information back to the transmitter). 2.Binding Procedure 2.1 Bind procedure: 1) Ascertain that the transmitter is in the PPM mode. Turn the transmitter off. 2) Turn on the transmitter while holding the F/S button on the transmitter module. Release the button. The RED LED on the transmitter module will flash, indicating the transmitter is ready to bind to the receiver. 3) Connect the provided binding cable to corresponding channels of VD5M (see 1.1 Compatibility chart for details), and connect battery to the receiver. LED on the receiver will flash, indicating the binding process is completed. Turn off both the transmitter and receiver, and disconnect the binding cable from VD5M. 4) Turn on the transmitter and connect the battery to the receiver. The RED LED on the receiver will indicate the receiver is receiving commands from the transmitter. The receiver/transmitter module binding will not have to be repeated, unless one of the two is replaced. Note: Make sure corresponding channels are connected by provided binding cable when working with the transmitter module.