Notice: The microphone is very sensitive; avoid dropping, knocking, or exposing it to strong shock. If the microphone is placed near a speaker, feedback or whistling may occur. To prevent this, position the microphone away from the speaker or reduce the speaker volume. Switching the pickup mode may produce noise. The battery indicator on the microphone lights up briefly when powered on and then turns off automatically to save power and prevent interference with video recording. Always check the switch to confirm it is turned off when the microphone is not in use. When the battery is low, the power indicator will flash once upon turning on. During use, if the power light illuminates steadily, this indicates low battery. The microphone can still operate for one to two hours under these conditions, but replace the battery promptly. Product Name: Microphone For Camera Model: MIC-01 Cable Length: Approximately 20cm Frequency Response: 30–15,000 Hz Sensitivity: -40 dB (0 dB = 1 V/Pa at 1 kHz) Polar Pattern: Single Directional x 2 Output Impedance: 200 Ohm Signal-to-Noise Ratio: 76 dB (1 kHz at 1 Pa) Maximum Sound Pressure Level: 120 dB at 1 kHz (harmonic distortion ≤1%) Power Supply: 3V DC Connector Type: MS (Mid-Side) Stereo Wired Battery Requirement: 3V CR2 battery Battery Life: Approximately 800 hours (at room temperature using included 3V CR2 lithium battery) Compatibility: Compatible with any D-SLR camera equipped with a 3.5mm microphone input and standard hot shoe mount How to Use: 1. Slide the adapter onto the camera’s hot shoe to securely mount the microphone. 2. Ensure the camera is powered off before connecting the microphone. Insert the L-shaped mini stereo plug into the camera’s microphone input port. Dimensions: 132 x 30.5 x 61 mm Material: ABS Color: Black Package Contents: 1 x Microphone (camera not included) 1 x Battery 1 x User Manual Note: This package includes only the items listed above. Other accessories shown are for illustration purposes only and are not included. Note: Lighting and display differences may cause slight variations in color between the product image and the actual item. Measurement tolerance: ±1–3 cm.